Car Scissor Jack 2T Auto Emergency Crank Lift Stand Labor-Saving Repair & Tire Replacement Tool with Wrench for SUV Vehicles

2026-04-06T11:46:39-04:00

Price: 30.99 - 46.99 (3 variants)

SPECIFICATIONS

Brand Name: DayPlus

Hign-concerned Chemical: None

Item Type: Car Jacks

Origin: Mainland China

2 Ton Scissor Jack Auto Car Emergency Crank Lift Stand Tool

Product Descriptions:
👉The 2Ton Scissor Jack can be used as a rugged replacement jack or an extra utility jack that can be stored in the trunk of your car.
👉With tooth gears, the scissor jack can be extended from 90mm(close position) to 360mm, more than enough to lift most vehicles.
👉The extra-wide base offers easy positioning and the free handle delivers on-the-spot quick response and speed when you need it.

Product Features:
❤️ Minimum height: 90MM
❤️ Maximum height: 360MM
❤️ Lifting: 2T
❤️ Color: Black
❤️ Material: Steel
❤️ Net weight: 2.3KG
❤️ Packign Size: 50cm*24cm*11cm
❤️ Scope: Suitable for small and medium sized vehicles. Such as: cars, Buick, Santana, Vietnam and other vehicles.

Package Included:
- Scissor jack * 1
- Hex Wrench * 1

WARNING
1. Study, understand and follow all instructions before operating this device.
2. Do not exceed rated capacity as designated by the height/capacity curve.(Sea below)
3. Use only on hard level surface.
4. Use for emergency tire changing only.
5. Never get beneath the vehicle when it is supported by the jack.
6. Activate the hazard warning flasher,turn off ignition, set parking brake, move automatic shift selector to park position. In case of a manual transmission, move gear selector into reverse position. In addition, the wheel diagonally opposite from the wheel being lifted shall be chocked in both directions.
7. Lift only on areas of the vehicle as specified by the vehicle manufacturer.
8. Follow tire changing procedure as per the vehicle manufacturer's owner's manual.
9. No alterations shall be made to this product.
10. Failure to heed these messages may result in personal injury and/or property damage.

HEIGHT/CAPACITY CURVE
This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position.

BEFORE USING
1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts.
2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock.
3. If the jack is found to be damaged, it should be removed from service until properly repaired.

OPERATING INSTRUCTIONS
1. Insert the jack handle into the hole of the handle socket.
2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket.
3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise.
4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly.

CARE AND MAINTENANCE
1. When jack is not in use, lifting arm should be in full down position.
2. Always keep jack clean and keep the screw and bearings well lubricated.

3. Store the handle with care.